Systems Network Router User Manual
78 © 2001- 2008 D-Link Corporation. All Rights Reserved.
Wired Configuration Guide
• ARP Mapping - responsible for maintaining the ARP Table used to correlate IP and MAC
addresses. The table contains both static entries and entries dynamically updated based on
information in received ARP frames.
• Routing Table Object - responsible for maintaining the routing table populated by local
and static routes.
CLI Examples
The diagram in this section shows a Unified Switch configured for port routing. It connects
three different subnets, each connected to a different port. The script shows the commands you
would use to configure a Unified Switch to provide the port routing support shown in the
diagram.
Figure 32. Port Routing Example Network Diagram
Example 1. Enabling routing for the Switch
Use the following command to enable routing for the switch. Execution of the command
enables IP forwarding by default.
config
ip routing
exit
3UBNET
3UBNET
3UBNET
0ORT
0ORT
0ORT
5NIFIED3WITCH
ACTINGASAROUTER