System information

Appendix
1. You can use the following to make console connection
- Select the appropriate serial port (COM port 1 or COM port 2).
- Set the data rate to 115200 baud.
- Set the data format to 8 data bits, 1 stop bit, and no parity. Set flow control to none.
- Under Properties, select VT100 for Emulation mode.
2. The CLI commands of DWS-3000 series are more Cisco-Like, default username is ‘admin’,
and password is none. While you get into the 1
st
level of system access, the command prompt
is “>” (ex. (DWS-3024) >), and you can use ‘?’ command to see what high level system
information it can present here. And press ‘space’ or ‘tab’ it will automatically complete the
command you’re typing.
3. Use ‘enable’ to get into 2
nd
level of system access, and no default password, so just press
‘enter’. In 2
nd
level of system access, the command prompt is “#” (ex. (DWS-3024) #), and
you can view all system information with the ‘?’ command. Following are some useful ones
for listed scenarios:
- show network
- show vlan port all
- show ip intereface brief
- show wireless ap status
- show wireless ap failure status
4. In 2
nd
level of system access, you can type ‘config’ to get into configuration mode.
5. You can logon to http://pmdap.dlink.com.tw/PMD
and to Product Data/ Switch/ Switch/
DWS-3000 Series, to find the latest firmware of Unified Switch as well as AP. Also the
manual of Web GUI & CLI for detail reference.
6. When you upgrade the Unified Switch, you need to upgrade Access Point as well. Please
refer to the upgrade instruction along with the firmware on PMD.
7. For more information regarding the deployment in the overlay structure, you can refer to the
coming white paper on PMD. The white paper will introduce about different deployment
topology, and things need to be noticed.