System information

1. Scenario 1 - Basic L2 Edge Setup: 1 Unified Switch + 2 APs
The diagram in this scenario shows a very basic L2 edge network configuration with one Unified
Switch and two access points. All devices are in the same L2 domain.
The objectives in this setup are as follows:
• Set up the minimum configuration for multiple APs
• Configure an AP with a static IP
• Configure an ACL to prevent wireless clients from accessing the Unified Switch1
management interface.
• Configure DHCP on the Unified Switch for wireless client address assignment.
• Understand some of the D-LINK Wireless Access Point features.
An overview of the configuration steps needed for Unified Switch and APs are as follows:
1. Disable DHCP on the APs and assign a static IP address to AP2.
2. Configure the Unified Switch1 DHCP server & address pool for Guest Network clients.
3. Configure an ACL to restrict access from clients on the Guest Network.
4. Attach the APs to Unified Switch1.
5. Validate the APs by adding them to the Valid AP database.
6. Save the configuration.
7. Perform tests.
Unified Switch1
AP1
AP2
Seamless Roaming
10.90.90.90/8
CL1
10.90.90.91/8
10.90.90.92/8
SSID:
Guest Network
SSID:
Guest Network