Manualshelf

System information

ManualsBrandsD-Link ManualsMusical equipmentUnified Access System DWS-3000 Series
31323334353637383940
VLAN ID VLAN Name Include Ports IP Address
VLAN 20 (Interface 4/1) AP1 Port 0/1 192.168.20.254
VLAN 30 (Interface 4/2) AP2 Port 0/13 192.168.30.254
VLAN 100 (Interface 4/3) D-LINK-NET1 Ports 0/1 and 0/13 192.168.100.254
VLAN 200 (Interface 4/4) D-LINK-NET2 Ports 0/1 and 0/13 192.168.200.254
VLAN 5 (Interface 4/5) Customer-NET Port 0/24 (Untag) 172.17.5.253
VLAN 250 (Interface 4/6) L3-Tunnel-NET Ports 0/21 and 0/22
(Untag)
192.168.250.254
Also, the default VLAN (PVID) for port 0/24 is 5, and the default VLAN for ports 0/21 and 0/22
is 250.
Use the following steps to create and configure VLAN 5, and then repeat them to configure
VLAN 250. Refer to the table for information about what value to configure for each VLAN.
1. From the LAN tab on the switch Web interface, click L2 Features Æ VLAN Æ VLAN
Configuration.
2. Select Create from VLAN ID and Name pull down menu.
3. Enter the VLAN ID.
4. Enter VLAN Name.
5. On the Slot/Port row for the port to include in the VLAN, select Include from the
Participation drop-down menu for the ports listed in the table.
6.
Click Submit.
Configure the Port VLAN ID for ports 0/21, 0/22, and 0/24.
1. From the LAN tab on the switch Web interface, click L2 Features Æ VLAN Æ Port
Configuration.
2.
Select port 0/21 from the Slot/Port drop-down menu.
3.
Enter 250 in the Port VLAN ID field.
4.
Click Submit.
5.
Select port 0/22 from the Slot/Port drop-down menu.
6.
Enter 250 in the Port VLAN ID field.
7.
Click Submit.
8.
Select port 0/24 from the Slot/Port drop-down menu.
9.
Enter 5 in the Port VLAN ID field.
10.
Click Submit.
11.
After you have repeated the steps to configure all four VLANs, use the Monitoring Æ
VLAN SummaryÆ VLAN Status and VLAN Port Status pages to verify that the
VLANs and the ports are configured properly.
3.1.2. Configure VLAN Routing
You need to configure two VLAN routing interfaces:
• An interface for the FTP/Audio/Video server that is attached to the L3 Tunnel subnet and
is used for WLAN clients on the Tunneled SSID Network.
• An interface that connects to the customer network (simulated here by the L3 device).
To configure the new VLAN routing interfaces, use the following steps.
1. Select the LAN tab from the navigation panel and click L3 Features Æ VLAN
Routing Configuration.