Manualshelf

System information

ManualsBrandsD-Link ManualsMusical equipmentUnified Access System DWS-3000 Series
31323334353637383940
This scenario builds on the configuration from Scenario 2. Although some of the information
configured in Scenario 2 does not apply to Scenario 3, you do not need to delete any of the pre-
existing configurations.
In addition to the VLAN, DHCP, ACL and Unified Switch configuration performed in Scenario 2,
the configuration for this scenario involves the following steps:
1. Assign a static IP address to AP2 or use a DHCP server on the customer L3 device or
configure DHCP Relay on the L3 customer device to point to a DHCP Server configured
on the unified switch.
2. Configure two additional VLANs and VLAN routing interfaces.
3. Configure a default route.
4. Add the IP address of AP2 to the L3 discovery list.
5. Configure and enable the L3 Tunnel network on the Unified Switch.
6. Apply the updated profile to the APs.
7. Save the configuration.
The following table shows a summary of the interfaces or devices you configure, along with their
IP address and port information. You configure the entries in bold in this scenario. All other
entries were configured in previous scenarios.
Interface/Device IP Address Port
Unified Switch Management
Interface
10.90.90.90/8 Any unused
Unified Switch Loopback
Interface
192.168.10.254/32 Logical only
Unified Switch L3 Tunnel
Interface
192.168.250.254/24 Logical only
Unified Switch Interface to
L3 Device
172.17.5.253/24 0/24
L3 Device Interface to
Unified Switch
172.17.5.254/24 L3 device port
FTP Server 192.168.250.x/24 0/21
Audio/Video Server 192.168.250.x/24 0/22
AP1 192.168.20.x/24 0/1
AP2 172.17.6.1/24 L3 device port
Clients on D-LINK-NET1 192.168.100.x/24 Wireless
Clients on D-LINK-NET2 192.168.200.x/24 Wireless
Clients on L-3 Tunnel 192.168.250.x/24 Wireless
3.1. Configuring LAN Settings
All of the features you configure in this section are within the LAN tab on the D-LINK Unified
Switch.
3.1.1. Configure the VLANs
The summary information for the VLAN configuration is as follows (the bold entries are new for
this scenario, and the grey entries were configured in Scenario 2):