System information

8. Create Rule 3 to allow all other type of traffic between any source and any destination since
as mentioned earlier, there is an implicit “deny all” rule at the end of every ACL.
9. From the Rule drop-down menu, select Create.
10. Enter 3 into the Rule ID field, Permit into the Action field, and True in the Match Every
field, and then click Submit.
Next, you must attach the ACL to port 0/1 and port 0/13 so that the rules are applied to the
appropriate wireless client traffic that goes through the APs connected to the switch.
1. From the ACL Æ Interface Configuration page,
2. Select port 0/1 from the Slot/Port drop-down menu.
3. Select IP ACL as the ACL Type.
4. Enter 1 as the sequence number, and click Submit.
5. Repeat the steps to associate ACL 100 with port 0/13.