System information

To begin the Unified Switch configuration, connect to port 12 from a PC on the 10.0.0.0 network
and launch the web browser using the default IP address: 10.90.90.90/8. You connect the APs
after you complete the entire switch configuration.
The IP address information for this scenario is as follows:
Device IP Address
Unified Switch Management Interface 10.90.90.0/8
Unified Switch Loopback Interface 192.168.10.254/32
AP1 192.168.20.x/24
AP2 192.168.30.x/24
Wireless Clients on D-LINK-NET1 192.168.100.x/24
Wireless Clients on D-LINK-NET2 192.168.200.x/24
2.1 Configuring LAN Settings
All of the features you configure in this section are within the LAN tab on the D-LINK Unified
Switch.
In this scenario, the switch is a L3 device with a total of four VLAN routing interfaces. Each
connected AP is in a different subnet, so you need to configure two separate VLAN routing
interfaces and configure an IP address for each interface. Each AP has three different VAPs
enabled, and each VAP uses a different SSID and VLAN. You create an ACL to block IP traffic
between clients on VAP1 and clients on VAP2, so you also need to configure VLAN routing
interfaces for the two VAPs. The third VAP is the Guest Network, which is not used in this
scenario.
When wireless clients connect to the AP, all traffic from the client is tagged with the VLAN ID
associated with the SSID that the client uses to connect. You must configure the VLAN
information on the switch so that client traffic is accepted on the ports. (Note: if the VLAN ID of
the SSID Network is equal to the untagged-VLAN configured on the AP, which by default is 1,
traffic on that Network will be untagged when injected into the network. A Radius server could
also be used to assign per-client VLAN assignments.)
1.1.1. Create VLANs
AP1 is connected to port 0/1, and AP2 is connected to port 0/13. The summary information for
the VLAN configuration is as follows:
VLAN ID VLAN Name Include Ports IP Address
VLAN 20 (Interface 4/1) AP1 Port 0/1 (Untag) 192.168.20.254
VLAN 30 (Interface 4/2) AP2 Port 0/13 (Untag) 192.168.30.254
VLAN 100 (Interface 4/3) D-LINK-NET1 Ports 0/1 and 0/13 (Tagged) 192.168.100.254
VLAN 200 (Interface 4/4) D-LINK-NET2 Ports 0/1 and 0/13 (Tagged) 192.168.200.254
Also, the default VLAN (PVID) for port 0/1 is 20, and the default VLAN for port 0/13 is 30.
Use the following steps to create and configure each VLAN. Repeat the steps to configure all four
VLANs. Refer to the table for information about what value to configure for each VLAN.
1. From the LAN tab on the switch Web interface, click L2 Features Æ VLAN Æ VLAN
Configuration.
2. Select Create from VLAN ID and Name pull down menu.