System information

58 © 2001- 2011 D-Link Corporation. All Rights Reserved.
Configuration Guide
Example #2: Show the Port Mirroring Session
(DWS-3024) #show monitor session 1
Session ID Admin Mode Probe Port Mirrored Port Type
---------- ---------- ---------- ------------- -----
1 Enable 0/8 0/7 Rx,Tx
(DWS-3024) #Monitor session ID “1” - “1” is a hardware limitation.
Example #3: Show the Status of All Ports
(DWS-3024) #show port all
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
---- ---- ------ -------- -------- ------ ---- ----
0/1 Enable Auto Up Enable Enable
0/2 Enable Auto Down Enable Enable
0/3 Enable Auto Down Enable Enable
0/4 Enable Auto Down Enable Enable
0/5 Enable Auto Down Enable Enable
0/6 Enable Auto Down Enable Enable
0/7 Mirror Enable Auto Down Enable Enable
0/8 Probe Enable Auto Down Enable Enable
0/9 Enable Auto Down Enable Enable
0/10 Enable Auto Down Enable Enable
Example #4: Show the Status of the Source and Destination Ports
Use this command for a specific port. The output shows whether the port is the mirror or the
probe port, what is enabled or disabled on the port, etc.
(DWS-3024) #show port 0/7
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
---- ---- ------ -------- -------- ------ ---- ----
0/7 Mirror Enable Auto Down Enable Enable
(DWS-3024) #show port 0/8
Admin Physical Physical Link Link LACP
Intf Type Mode Mode Status Status Trap Mode
---- ---- ------ -------- -------- ------ ---- ----
0/8 Probe Enable Auto Down Enable Enable