Quick Installation Guide

What do I do if my smart plug is not working
properly?
Reset the smart plug and reinstall the smart plug.
To reset your smart plug, press and hold the Reset
button until the LED turns solid red.
During installation, ensure that:
• you have an Internet connection on your router
• your router’s Wi-Fi is on
• your mobile device is connected to the Internet
How can I use voice commands to control my
smart plug?
The smart plug will work with both Amazon Alexa and
the Google Assistant. For setup instructions on these
services, visit the following websites:
Alexa:
https://www.dlink.com/en/alexa
The Google Assistant:
https://www.dlink.com/en/google-assistant
FAQPrecautions
• Plug into a grounded electrical outlet. Do not
plug into an extension cord or power strip.
• If plugged into an outlet controlled by a wall
switch, assure that the switch is left in the on
position and is never turned off.
• Ensure that the plugs in the housing are facing
downwards.
• Do not exceed the electrical ratings.
• Keep away from children and pets.
• Do not open the unit to modify or repair it.
• Unplug from wall socket before cleaning.
Electric shock can cause serious injury or
death. Install only in a dry environment.
Do not place near any source of water or
potential flooding zones.
!
?
Device Information
i
Booting up / Resetting
Connected to Wi-Fi
Ready for setup / Disconnected
Firmware being upgraded
Reset Button
/ System Status LED
Left Socket
Power Button
/ Power Status LED
Right Socket
Power Button
/ Power Status LED
System Status LED
Power Status LED
Switched on
Switched off
Place at the desired location at
least 2 feet from the ground.
Use a pencil to mark the hole
behind the mounting tab.
Use a 15/64" drill bit to drill
a 1-inch deep hole over the
pencil mark. Insert the plastic
anchor to support the screw.
Twist the screw into the
anchor. Leave 1/4" of the screw
exposed from the wall.
Align the screw with the hole
on the mount. Slide the mount
down to lock into place,
allowing it to hang.
Do not over tighten the screw.
Mounting
1 /
2 /
3 /
4 /
To install this product, you will need:
• A 802.11n/g router
• An Internet connection
• An e-mail account (required to register for
mydlink service)
• The mydlink™ app is available for iPhone®, iPad®
and Android™ devices. Please refer to the mobile
app's store page to check whether your device is
compatible.
• An available power outlet
• Wall space under the outlet to mount the device
Minimum Requirements
©2019 All rights reserved. D-Link and the D-Link logo
are registered trademarks of D-Link Corporation or its
subsidiaries. Product specification, size and shape are
subject to change without notice, and actual product
appearance may differ from that depicted on the
package. Visit dlink.ca for more details.
Support
For troubleshooting tips and more
information, visit:
Canada - http://support.dlink.ca
USA - support.dlink.com
Version 1.00 (CA)_70X110 || June 6, 2019