User's Manual

Section 4 – Troubleshooting
D-Link DSL-2740E User Manual
42
Routing
Static Routing
Choose ADVANCED > Routing > Static Route. The page shown in the right
figure appears. This page is used to configure the routing information. In this
page, you can add or delete IP routes.
The following table describes the parameters of this page.
Field
Description
Destination
The destination IP address of the router.
Subnet Mask
The subnet mask of the destination IP
address.
Next hop
The gateway IP address of the router.
Metric
The cost of this route.
Interface
The interface name of the router output
port.
Click Add Route to add a static route.
IPv6 Static Routing
Choose ADVANCED > Routing > IPv6 Static Route. The page shown in the
right figure appears. This page is used to configure the routing information. In
this page, you can add or delete IP routes.
Click Add to add a static route.
The following table describes the parameters of this page.
Field
Description
Destination
The destination IP address of the static
route.
Prefix length
The length of prefix for this route.
Next Hop
The gateway IP address of the static route.
Interface
The interface name of the static route.