User's Manual

Section 4 – Troubleshooting
D-Link DSL-2740E User Manual
19
DHCP server
The DHCP Server shown in the right figure appears. It used to assign an IP
address to clients connect to LAN of this CPE.
It is suggest to keep it as default settings.
Step 1 Configure DHCP Server.
- Enable DHCP Relay: Enable the message to transmit between
clients in different network segment.
- Enable DHCP Server: Enable the router to assign IP addresses, IP
default gateway and DNS Servers to the host.
DHCP IP Address Range: It specifies the first IP address in the IP
address pool. The router assigns IP address that base on the IP pool
range to the host.
DHCP Lease Time: The lease time determines the period that the
host retains the assigned IP addresses before the IP addresses
change.
Step 2 Select the LAN or WAN ports which are going to adopt the setting.
Step 3 Click Apply to make the settings take effect.
DHCP reserved
The DHCP Server shown in the right figure appears. It used to assign an IP
address to clients connect to LAN of this CPE.
It is suggest to keep it as default settings.