Operation Manual

189D-Link ShareCenter DNS-320L User Manual
Section 4 - Conguration
USB Devices
UPS Settings
Network UPS is a system management feature that uses a local UPS to protect your NAS from an abnormal shutdown due to a
power failure.
To enable Network UPS to your NAS (Network Slave Mode):
1. Click to enable the Network UPS.
2. Enter an IP address of the Network UPS Master.
3. Click Save Settings to receive the critical power status from the network
UPS master.
The UPS Status will display the current status of your UPS.
Note: Make sure that the ShareCenter is in the same network as the network UPS
master.
If a UPS device is connected to the USB port on your NAS, you can select either
Stand-Alone or Master mode. If you select Master mode, you will have to enter
the IP address(es) of the network UPS slaves to notify them in the event of a
power failure. For more details, refer to UPS Connectivity on page 386.