Specifications

13
Using the Setup Wizard (continued)
You must change the
Admin ID and Password
immediately to protect your
camera against unauthorized
access. By default, the
Admin ID and Password are
blank. To change the Admin
ID and Password, select both
Change boxes and enter a
New ID and New Password.
Click Next
The IP Address and Subnet
Mask of your camera and
Gateway must correspond
with your network settings for
you to access the camera. If
you are unsure of what these
settings should be, please
check with your network
administrator.
Click Next
Click Wizard
to begin
Your camera’s IP Address will be
displayed here if it is valid.
To run the Setup Wizard, click on
Start->Programs->DCS-900 Series
SetupWizard.