User's Manual

Note: if the second handset didn’t answer the transferred call within 30 seconds, the first handset will ring
alarming user to get back the return call.
Line SWAP
When the first line is under talking mode, the second line is ringing and the signal of line is
blinking too. To temporarily hold the conversation on the first line , and to get the second line,
After finishing the second line conversation, get back to the first line and continue the
conversation. While the first line caller is putting on hold, the caller will hear bi-bi tone until
the line resumed.
Making line swap
To make line swap:
1. When conversation in the line 1 (under the talking mode) on handset, the other line (line 2)
is calling in at this time, you will hear the instruction tone from handset reminding you
have line 2 calling. Line 1 and Line 2 indicators on LCD are blinking too. During the
handset is under talking with line 1, the display showing “ CONF HOLD “.
2. Handset press Right soft key to select HOLD function. The line 1 is hold, at this time, the
handset is ringing.
3. handset press the other ringing line (LINE 1 or LINE 2 button) to get connection with the
second caller.
4. press EXIT button to end conversation with the second line,
5. to resume the first line conversation, press the first line button (LINE 1 or LINE 2 button,
the one with LED is on) again.
6. to end the conversation with the first line, base press EXIT button.
CONFERENCE CALL
When Handset (or base) is in conversation with outside line, you can invite the third party to
join the conference call. The third party could be caller/dialer from the second line or the other
extension of this system.
Making 3-way conference call
To make 3-way conference call among base, handset and outside line:
Base is under conversation with outside line and invite handset to join conference call.
1. When conversation in the line (under the talking mode) on base by speakerphone (or by