User's Manual

03 RING SELECT
To choose the number of times the phone rings before the Answering System responds, set the
Ring Select switch to 3R, 5R or Toll SAVER.
Set to 3R - System answers call after the third ring.
Set to 5R - System answers call after the fifth ring.
Set to Toll Saver - when you will be checking your system for message from a remote location
using long distance services or from a pay phone.
To set ringing selection:
Under Standby mode
1. press MENU button,
2. use UP or DOWN to select 03 RING SELECT, press OK button
3. use UP or DOWN button to select 01 3 RINGS, or 02 5 RINGS, or 03 TOLL SAVER, press
OK to save it.
4. A three-beep sound emit out to confirm the setting.
04 MSG ALERT
When the message alert is ON, the unit will generate a beep sound every 15 seconds after a
new message has been recorded. If you do not want to hear the beep sound on every 15
seconds, to set the message alert to OFF position.
To set message alert:
Under Standby mode
1. press MENU button,
2. use UP or DOWN to select 03 MSG ALERT, press OK button
3. use UP or DOWN button to select 01 ALERT ON or 02 ALERT OFF, press OK to save it.
4. A three-beep sound emit out to confirm the setting.
05 ANNOUNCEMENT
To set Announce mode means to set up your system answers incoming calls with your
recorded announcement but it will not record any ICMs. (incoming call messages). Please see
the detail operation manual on Answering System.
To set announcement:
Under Standby mode
1. press MENU button,
2. use UP or DOWN to select 05 ANNOUNCE, press OK button
3. use UP or DOWN button to select 01 ANNOC ON or 02 ANNOC OFF, press OK to save it.
4. A three-beep sound emit out to confirm the setting.
06 SCREEN CALL