User's Manual

Handset is under conversation with outside line and invite base to join conference call.
1. when handset is on the line, the screen shows “ CONF HOLD “,
2. Select CONF from handset screen by pressing Left Shift key (soft key) on handset
3. screen shows “ DIAL INTER “.
4. Select INTER by pressing Right softkey on right side,
5. Handset then press “ *” star button (to call base), handset screen show “ NO:BS ”,
6. handset press OK, Base will keep ringing two-tone sound and display showing “ HS
CALLING “
7. Base press PAGE button to get connection with handset; at this time, handset shows
“ CONF RETRV’
8. handset select CONF by pressing OK (soft key) to activate 3-way conference.
To make 3-way conference call among handset, the second handset and outside line:
1. When conversation in the line (under the talking mode) on handset - 01 with outside line
caller,
2. Handset - 01 LCD screen is showing “ CONF HOLD ” ,
3. Handset - 01 select CONF by pressing Left softkey, the screen is showing “ DIAL
INTER “,
4. Handset - 01select INTER by pressing Right soft key, the screen showing “ NO: “.
5. Dial the second handset # , for example, 02, then press OK button,
6. At this time, Handset-02 will ring. Handset-02 press OK button to intercom with
Handset-01,
7. Handset-01 select CONF by pressing Left soft key to activate conference call among
Handset-01 , the caller from CO line, and Handset-02. The handsets display
“ CONFERENCE”.
To make 3-way conference call among Line 1, Line 2 and Base:
1. When conversation in the Line 1 (under the talking mode) on base by speakerphone (or by
handphone) with outside line caller,
2. Base press CONF button, the screen shows “CONF “ ,
3. Base press Line 2 to get with the third party , the screen shows “ Talking “,
4. Base press CONF button again to activate conference call among base, the outside caller
in CO line, and handset.
Note: we found above steps are correct in 100DAM and 400DAM.
Caller ID System