User's Manual

To Set Number of Rings before answering
You can set the number of rings answering machine waits before answering. Three options to set: 3
rings, 5 rings, or Toll Saver. The default is 5 rings.
To set the number of rings:
1. Press MENU button (refer to MENU – 04 RING SELECT)
2. Scroll UP or DOWN button to select: 04 RING SELECT. There are 3 rings (#01), 5 rings (#02),
and Toll Saver (#03).
3. Press OK to confirm
To page handset
If you expand multiple handsets for the telephone system, the telephone base page to all handsets or
any handset.
To page all handsets:
Under standby mode in base,
1. press PAGE button, the display shows INTER:HS,
2. press PAGE button again, all the handsets registered with this base will be ringing at this
time.
3. Any one of handset to pick up the paging by pressing any key to enable the intercom with
base. At this moment, the rest of handsets will stop ringing.
4. when display showing INTER:HS, dial handset number, the handset will ring. Base could
be as a finder of handset.
Above is the text I sent to you/Daniel. It’s same step as you revised it.
Base Intercom with Handset:
When base feel like to have conversation with a particular handset, and Base is under standby
mode,
1. Base press PAGE button, and the screen shows “ INTER:HS “
2. then dial handset number, for example “INTER: 15” at this time, press OK,
3. the handset will be ringing, the handset screen shows “ BASE PAGING “
4. handset press any button to pick up intercom with base.
5. handset press EXIT button to stop intercom with Base.
Note: if an outside call come in, you will hear a instruction tone from phone ( to remind you having a outside
call ringing ) while you are busy on talking intercom with your base or handset.
Caller ID call back