User manual

66D-Link DAP-1555 User Manual

Section 4 - Security

Conﬁgure WPA-Personal (PSK) In AP Mode

It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please

establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption

due to the added overhead.

1. Log into the web-based conﬁguration by opening a web browser

and entering the IP address of the access point (192.168.0.50).

Click on Setup and then click Wireless Settings on the left

side.

2. Next to Security Mode, select WPA-Personal.

3. Next to WPA Mode, select Auto, WPA2 Only, or WPA Only.

Use Auto if you have wireless clients using both WPA and

WPA2.

4. Next to Cipher Type, select TKIP, AES, or TKIP and AES.

5. Next to Group Key Update Interval, enter the amount of time

before the group key used for broadcast and multicast data is

changed (3600 is default).

6. Next to Pre-Shared Key, enter a key (passphrase). The key is entered as a pass-phrase in ASCII format at both ends

of the wireless connection. The pass-phrase must be between 8-63 characters.

7. Click Save Settings to save your settings. If you are conﬁguring the access point with a wireless adapter, you will lose

connectivity until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the access

point.