Quick Installation Guide

DIS-3650AP Quick Installation Guide
5
ENGLISH
Figure 12: Attaching the Grounding Wire
3. A grounding wire is to protect your device
from lightning strikes and the buildup of
static electricity. Attach the grounding
wire to the DIS-3650AP using the included
screw(M3.9 * 7.8 mm).
Figure 13: Attaching the Grounding Wire
Installation for DIN Rail
The DIS-3650AP can be mounted on a standard
DIN rail using the included DIN mounting kit.
Use the following instructions to install the DIS-
3650AP on a rail:
1. Install a Din rail kit on enclosure. Check that
the DIN rail kit is installed properly using
two screws on each end.
Figure 10
2. Position the DIS-3650AP against the rail,
then tilt it upwards and hook the DIN rail
clip on the back of the device against the
rail. Snap the device into place to complete
the installation.
Figure 11