Quick Installation Guide Wireless AC1200 Wave 2 Industrial Outdoor Access Point DIS-3650AP Additional documentation is also available on the D-Link website
System Requirements This installation guide provides instructions for installing the DIS-3650AP on your network. Additional documentation is also available on the D-Link support website. • • • Nuclias Connect Manual: For additional information and instructions on how to configure the device using Nuclias Connect. DIS-3650AP User Manual: For additional information and instructions on how to configure the device using the web user interface.
ENGLISH Interface Connectors # Connector DIN rail 1 Adapter Wall/Pole 2 Mount Grounding 3 Wire Description Connect DIN rail kit to mount it on DIN-Rail. Mount to connect to the mounting plate on a wall or a pole. Connector for the grounding wire. Table 3: Interface Description 1 2 3 Installation Figure 2: Top Connectors # Connector 1 2 3 Description Gigabit RJ-45 port for data and LAN(PoE) Power over Ethernet (PoE) power.
2. Open the Nuclias Connect app and follow the onscreen instructions to discover and set up your device. Manual Configuration Use one of the following methods to access the web user interface: Install Enclosure Onto The Articulation Pole Attach the articulation pole to back of AC using M5x16 screws & washers. Connecting through Ethernet 1. 2. 3. Use an Ethernet cable to connect the DIS-3650AP to the switch or router the management computer is connected to. Manage the access point from a computer.
Installation for Pole ENGLISH Mounting for Recommended Pole Dia.: 1.5~2”(38.1~50.8mm) Mounting for Pole 1~ 3” (25.4~76.2mm) Fix the T-from Bracket to the pole by using the stainless hose clamp. (A) (B) Figure 8 Install Articulation Pole with The T-formed Bracket After finishing the previous two steps, fix the articulation pole to the T-formed bracket by using M8x40 bolts, nut, spring washer and washer.
Installation for DIN Rail 1. ENGLISH The DIS-3650AP can be mounted on a standard DIN rail using the included DIN mounting kit. Use the following instructions to install the DIS3650AP on a rail: Install a Din rail kit on enclosure. Check that the DIN rail kit is installed properly using two screws on each end. Figure 12: Attaching the Grounding Wire 3. Figure 10 2. Position the DIS-3650AP against the rail, then tilt it upwards and hook the DIN rail clip on the back of the device against the rail.
Tighten the grounding wire (green-andyellow, 18AWG) to the DIS-3650AP until it is securely attached. ENGLISH 4. Professional installation instruction 1. Installation personal This product is designed for specific application and needs to be installed by a qualified personal who has RF and related rule knowledge. The general user shall not attempt to install or change the setting. 2.
Appendix - Statements This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. ENGLISH Product and Warranty Information To find out more about D-Link Nuclias product or marketing information, please visit the website http:// www.dlink.com or https://www.nuclias.com. The D-Link Limited Lifetime Warranty information is available at http://www.dlink.com/warranty 1. Instructions for the installation of that conductor to building earth by a SKILLED PERSON. 2.
Notes
Notes
Notes
Notes
Ver. 1.
