User's Manual

50D-Link DIR-842 User Manual
Section 4 - Conguration
Network
Enter the IP address of the router. The default IP address is
.
If you change the IP address, once you click Save, you will need
to enter the new IP address in your browser to get back into the
conguration utility.
Enter the subnet mask of the router. The default subnet mask is
.
The default address to access the router’s configuration is
IUUQEMJOLSPVUFSMPDBM Here, you can replace dlinkrouter with
a name of your choice.
&OUFSUIFEPNBJOOBNFPQUJPOBM
Disable to transfer the DNS server information from your ISP to your
computers. If enabled, your computers will use the router for a DNS
server.
Enable or disable the DHCP server.
Enter the starting and ending IP addresses for the DHCP server’s IP
assignment.
Note: If you statically (manually) assign IP addresses to your computers
or devices, make sure the IP addresses are outside of this range or you
may have an IP conict.
LAN IP Address:
Subnet Mask:
Management
Link:
Local Domain
Name:
Enable DNS
Relay:
Status:
DHCP IP
Address Range:
This section will allow you to change the local network settings of the router and to
congure the DHCP settings. In the Settings menu on the bar on the top of the page,
click Network. Click "EWBODFE4FUUJOHT to expand the list and see all of the options.