User's Manual

96D-Link DIR-842 User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP
TFSWFSJFXJSFMFTTSPVUFSBVUPNBUJDBMMZ5PWFSJGZZPVS*1BEESFTTQMFBTFGPMMPXUIFTUFQTCFMPX
Click on Start > Run. In the run box type cmd and click 0,8JOEPXT¥7JTUB¥VTFSTUZQFcmd in the Start SearchCPY
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the
default gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation,
security settings, and the settings on your router.
Some rewall software programs may block a DHCP
request on newly installed adapters.