User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Quick Setup Wizard
- Web-based Configuration Utility
- Setup Wizard
- Manual Configuration
- Internet Setup
- Wireless Settings
- Network Settings
- IPv6 Internet Connection
- IPv6 Internet Connection Setup Wizard
- IPv6 Manual Setup
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Application Level Gateway Configuration
- Routing
- Advanced Wireless Settings
- Wi-Fi Protected Setup (WPS)
- Advanced Network Settings
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Administrator Settings
- Time Settings
- SysLog
- Email Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Stats
- Active Sessions
- Wireless
- IPv6
- IPv6 Routing
- Support
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
21D-Link DIR-653 User Manual
Section 3 - Conguration
If you selected Dynamic, you may need to enter the MAC address of the computer that was
last connected directly to your modem. If you are currently using that computer, click Clone
Your PC’s MAC Address and then click Next to continue.
The Host Name is optional but may be required by some ISPs. The default host name is the
device name of the Router and may be changed.
If you selected PPPoE, enter your PPPoE username and password. Click Next to continue.
Select Static if your ISP assigned you the IP address, subnet mask, gateway, and DNS server
addresses.
Note: Make sure to remove your PPPoE software from your computer. The software is no longer
needed and will not work through a router.
If you selected PPTP, enter your PPTP username and password. Click Next to continue.