User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Quick Setup Wizard
- Web-based Configuration Utility
- Setup Wizard
- Manual Configuration
- Internet Setup
- Wireless Settings
- Network Settings
- IPv6 Internet Connection
- IPv6 Internet Connection Setup Wizard
- IPv6 Manual Setup
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Application Level Gateway Configuration
- Routing
- Advanced Wireless Settings
- Wi-Fi Protected Setup (WPS)
- Advanced Network Settings
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Administrator Settings
- Time Settings
- SysLog
- Email Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Stats
- Active Sessions
- Wireless
- IPv6
- IPv6 Routing
- Support
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
9D-Link DIR-653 User Manual
Section 2 - Installation
Before you Begin
Installation
This section will walk you through the installation process. Placement of the router is very important. Do not place the router in an enclosed area
such as a closet, cabinet, or in the attic or garage.
Please congure the router with the computer that was last connected directly to your modem. Also, you can only use the Ethernet port on your
modem. If you were using the USB connection before using the router, then you must turn o your modem, disconnect the USB cable and connect
an Ethernet cable to the Internet port on the router, and then turn the modem back on. In some cases, you may need to call your ISP to change
connection types (USB to Ethernet).
If you have DSL and are connecting via PPPoE, make sure you disable or uninstall any PPPoE software such as WinPoet, Broadjump, or Enternet 300
from your computer or you will not be able to connect to the Internet.