User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Quick Setup Wizard
- Web-based Configuration Utility
- Setup Wizard
- Manual Configuration
- Internet Setup
- Wireless Settings
- Network Settings
- IPv6 Internet Connection
- IPv6 Internet Connection Setup Wizard
- IPv6 Manual Setup
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Application Level Gateway Configuration
- Routing
- Advanced Wireless Settings
- Wi-Fi Protected Setup (WPS)
- Advanced Network Settings
- Guest Zone
- IPv6 Firewall
- IPv6 Routing
- Administrator Settings
- Time Settings
- SysLog
- Email Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Stats
- Active Sessions
- Wireless
- IPv6
- IPv6 Routing
- Support
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
99D-Link DIR-653 User Manual
Section 5 - Connecting to a Wireless Network
Congure Wireless Security
It is recommended to enable wireless security (WPA/WPA2) on your wireless router or access point before conguring your wireless adapter. If you
are joining an existing network, you will need to know the security key or passphrase being used.
2. Highlight the wireless network (SSID) you would like to connect to and
click Connect.
1. Open the Windows Vista® Wireless Utility by right-clicking on the wireless
computer icon in your system tray (lower right corner of screen). Select
Connect to a network.