User's Manual Part 1
15D-Link DIR-652 User Manual
5GEVKQP%QPſIWTCVKQP
Select 000O%5SERNAME0ASSWORD from the drop-down menu.
Select Static if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
Enter the IP address (Static PPPoE only).
Enter your PPPoE user name.
Enter your PPPoE password and then retype the password in the next
box.
Enter the ISP Service Name (optional).
Select either Always on, On demand, or Manual.
Enter the Primary and Secondary DNS Server Addresses (Static PPPoE
only).
Enter a maximum idle time during which the Internet connection is
maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Maximum Transmission Unit - you may need to change the MTU for
QRVKOCNRGTHQTOCPEGYKVJ[QWTURGEKſE+52KUVJGFGHCWNV/67
The default MAC Address is set to the Internet port’s physical interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address unless required by your ISP. You can use the Clone Your PC’s
MAC Address button to replace the Internet port’s MAC address with the MAC address of your Ethernet card.
My Internet
#ONNECTION
!DDRESS-ODE
)0!DDRESS
5SER.AME
0ASSWORD
3ERVICE.AME
Reconnection
-ODE
Maximum Idle
4IME
$.3!DDRESSES
-45
-!#!DDRESS
)NTERNET3ETUP
000O%$3,
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username
and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software
is no longer needed and will not work through a router.