User's Manual

43D-Link DIR-645 User Manual
Section 3 - Software Configuration
IPv6 Connection Type: Autoconfiguration (SLAAC/DHCPv6)
In the following section we’ll discuss the parameters that can be configured when
setting up an Autoconfiguration (SLAAC/DHCPv6) connection. This is a method of
connection where the ISP assigns your IPv6 address when your router requests one
from the ISP’s server. Some ISP’s require you to make some settings on your side
before your router can connect to the IPv6 Internet.
The following parameters will be available for configuration:
Obtain IPv6
DNS Servers
automatically:
Select this option to obtain the DNS Server addresses
automatically.
Use the following
IPv6 DNS
Servers:
Select this option to manually enter the DNS Server
addresses used.
Primary DNS
Server:
Enter the WAN primary DNS Server address used here.
Secondary DNS
Server:
Enter the WAN secondary DNS Server address used here.
The following parameters will be available for configuration:
Enable DHCP-PD:
Select this option to enable DHCP PD.
LAN IPv6
Address:
Enter the LAN IPv6 address used here. This address must be in the ‘/64’ subnet.
LAN IPv6 Link-
Local Address:
Displays the LAN IPv6 Link-Local address used here.