User's Manual

37D-Link DIR-645 User Manual
Section 3 - Software Configuration
Set Static IPv6 Address Connection
This mode is used when your ISP provides you with a set IPv6 addresses that does
not change. The IPv6 information is manually entered in your IPv6 configuration
settings. You must enter the IPv6 address, Subnet Prefix Length, Default Gateway,
Primary DNS Server, and Secondary DNS Server. Your ISP provides you with all this
information.
The following parameters will be available for configuration:
Use Link-Local
Address:
The Link-local address is used by nodes and routers when
communicating with neighboring nodes on the same link.
This mode enables IPv6-capable devices to communicate
with each other on the LAN side.
IPv6 Address:
Enter the WAN IPv6 address for the router here.
Subnet Prefix
Length:
Enter the WAN subnet prefix length value used here.
Default Gateway:
Enter the WAN default gateway IPv6 address used here.
Primary IPv6 DNS
Address:
Enter the WAN primary DNS Server address used here.
Secondary IPv6
DNS Address:
Enter the WAN secondary DNS Server address used here.
LAN IPv6
Address:
These are the settings of the LAN (Local Area Network) IPv6 interface for the router. The router’s LAN IPv6 Address configuration is based on the IPv6
Address and Subnet assigned by your ISP. (A subnet with prefix /64 is supported in LAN.)
Click on the Next button to continue. Click on the Prev button to return to the previous page.
Click on the Cancel button to discard all the changes made and return to the main page.