User's Manual

75D-Link DIR-836L User Manual
Section 3 - Conguration
&OUFSB OBNFGPSUIFSVMF:PVNBZTFMFDU B
pre-dened application from the drop-down menu
and click <<.
This is the port used to trigger the application. It
can be either a single port or a range of ports.
Select the protocol of the trigger port (TCP, UDP,
or Both).
This is the port number on the Internet side that
XJMMCF VTFEUPBDDFTTUIF BQQMJDBUJPO:PV NBZ
EFöOFBTJOHMFQPSUPSBSBOHFPGQPSUT:PVDBOVTF
a comma to add multiple ports or port ranges.
Select the protocol of the rewall port (TCP, UDP,
or Both).
5IFTDIFEVMFPGUJNFXIFOUIF"QQMJDBUJPO3VMF
will be enabled. The schedule may be set to Always,
which will allow the particular service to always
CFFOBCMFE:PVDBODSFBUFZPVSPXOUJNFTJOUIF
Tools > Schedules section.
Name:
Trigger:
Trac Type:
Firewall:
Trac Type:
Schedule:
Application Rules
4PNFBQQMJDBUJPOTSFRVJSFNVMUJQMFDPOOFDUJPOTTVDIBT*OUFSOFUHBNJOHWJEFPDPOGFSFODJOH*OUFSOFUUFMFQIPOZBOEPUIFST
These applications have diculties working through NAT (Network Address Translation). Special Applications makes some of
UIFTFBQQMJDBUJPOTXPSLXJUIUIF%*3-*GZPVOFFEUPSVOBQQMJDBUJPOTUIBUSFRVJSFNVMUJQMFDPOOFDUJPOTTQFDJGZUIFQPSU
normally associated with an application in the “Trigger Port” eld, select the protocol type as TCP or UDP, then enter the rewall
(public) ports associated with the trigger port to open them for inbound trac.
5IF%*3-QSPWJEFTTPNFQSFEFöOFEBQQMJDBUJPOTJOUIFUBCMFPOUIFCPUUPNPGUIFXFCQBHF4FMFDUUIFBQQMJDBUJPOZPV
want to use and enable it.