User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Wireless Security
- Connect to a Wireless Network
- Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista)
- Changing the Computer Name and Joining a Workgroup
- Configuring the IP Address in Vista
- Setting Up a Connection or Network Wirelessly
- Connecting to a Secured Wireless Network (WEP, WPA-PSK & WPA2-PSK)
- Connecting to an Unsecured Wireless Network
- Configuring the Network in MAC OS X Snow Leopard (10.6)
- Configuring the Wireless Network in MAC OS X Snow Leopard (10.6)
- Troubleshooting
- Wireless Basics
- Networking Basics
43D-Link DIR-627 User Manual
Section 6 - Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista)
SettingUpaConguredRouter
Once the Router has been congured, you can use the push button on the Router or third party software to invite a
newcomer to join your Wi-Fi protected network. For maximum security, the software method is recommended. However,
the push button method is ideal if there is no access to a GUI.
If you are using the Router’s Wi-Fi Security push button option, simultaneously depress the push button located on
the side of the Router and the button on the client (or virtual button on the client’s GUI). Next click Finish. The Client’s
software will then allow a newcomer to join your secure, Wi-Fi protected network.
If you are using third party software, run the appropriate Wi-Fi Protected System utility. You will be asked to either use
the push button method or to manually enter the PIN. Follow the on-screen instructions.