User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Wireless Security
- Connect to a Wireless Network
- Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista)
- Changing the Computer Name and Joining a Workgroup
- Configuring the IP Address in Vista
- Setting Up a Connection or Network Wirelessly
- Connecting to a Secured Wireless Network (WEP, WPA-PSK & WPA2-PSK)
- Connecting to an Unsecured Wireless Network
- Configuring the Network in MAC OS X Snow Leopard (10.6)
- Configuring the Wireless Network in MAC OS X Snow Leopard (10.6)
- Troubleshooting
- Wireless Basics
- Networking Basics
32D-Link DIR-627 User Manual
Section 4 - Security
CongureWPA2-PSK
It is recommended to enable encryption on your wireless Router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1. Log into the Web-based conguration by opening a Web browser and entering the IP address of the router
(192.168.0.1). Click Security at the top of the window.
2. Go to 802.11Authentication and select Open.
3. Go to WPA2-PSK and toggle Disabled to Enabled.
4. Go to WPAEncryption and select AES or TKIP+AES.
5. Go to WPAPassphrase and enter the WPA Passphrase that is being used on your wireless network.
6. Click Apply to save your settings. If you are conguring the Router with a wireless adapter, you will lose connectivity
until you enable WPA-PSK on your adapter and enter the same passphrase as you did on the Router.