User's Manual
Table Of Contents
- Package Contents
- Installation
- Configuration
- Wireless Security
- Connect to a Wireless Network
- Setting Up Wi-Fi Protection (WCN 2.0 in Windows Vista)
- Changing the Computer Name and Joining a Workgroup
- Configuring the IP Address in Vista
- Setting Up a Connection or Network Wirelessly
- Connecting to a Secured Wireless Network (WEP, WPA-PSK & WPA2-PSK)
- Connecting to an Unsecured Wireless Network
- Configuring the Network in MAC OS X Snow Leopard (10.6)
- Configuring the Wireless Network in MAC OS X Snow Leopard (10.6)
- Troubleshooting
- Wireless Basics
- Networking Basics
21D-Link DIR-627 User Manual
Section 3 - Conguration
Radio
The Radio page allows users to congure the physical wireless interfaces.
Choose either Enabled or Disabled. This enables
or disables the wireless interface.
Set the channel on which to operate on: Auto, 1,
2, 3, 4, 5, 6, 7, 8, 9, 10, or 11.
Choose either Auto or Off to enable or disable
802.11n support.
Choose the channel bandwith, either 20 MHz in
Both Bands or 40 MHz in Both Bands.
Set the NPHY Rate (MCS Index): Auto, Use Legacy
Rate, 0: 6.5 Mbps, 1: 13 Mbps, 2: 19.5 Mbps, 3:
26 Mbps, 4: 39 Mbps, 5: 52 Mbps, 6: 58.5 Mbps,
7: 65 Mbps, 8: 13 Mbps, 9: 26 Mbps, 10: 39 Mbps,
11: 52 Mbps, 12: 78 Mbps, 13: 104 Mbps, 14: 117
Mbps, or 15: 130 Mbps.
Set the fragmentation threshold. The default is
2346.
Set the Request to Send (RTS) threshold. The
default is 2346.
Set the Delivery Trafc Indication Message (DTIM)
value. This is the wakeup interval for clients in
power save mode. The default is 1.
Set the beacon interval for the access point. The
default is 100.
Interface:
Control
Channel:
802.11n
Mode:
Bandwidth:
NPHYRate:
Fragmentation
Threshold:
RTS
Threshold:
DTIM
Interval:
Beacon
Interval: