User's Manual
Table Of Contents
- 2.pdf
- 3.pdf
- 4.pdf
- 5.pdf
- 6.pdf
- 7.pdf
- 8.pdf
- 9.pdf
- 10.pdf
- 11.pdf
- 12.pdf
- 13.pdf
- 14.pdf
- 15.pdf
- 16.pdf
- 17.pdf
- 18.pdf
- 19.pdf
- 20.pdf
- 21.pdf
- 22.pdf
- 23.pdf
- 24.pdf
- 25.pdf
- 26.pdf
- 27.pdf
- 28.pdf
- 29.pdf
- 30.pdf
- 31.pdf
- 32.pdf
- 33.pdf
- 34.pdf
- 35.pdf
- 36.pdf
- 37.pdf
- 38.pdf
- 39.pdf
- 40.pdf
- 41.pdf
- 42.pdf
- 43.pdf
- 44.pdf
- 45.pdf
- 46.pdf
- 47.pdf
- 48.pdf
- 49.pdf
- 50.pdf
- 51.pdf
- 52.pdf
- 53.pdf
- 54.pdf
- 55.pdf
- 56.pdf
- 57.pdf
- 58.pdf
- 59.pdf
- 60.pdf
- 61.pdf
- 62.pdf
- 63.pdf
- 64.pdf
- 65.pdf
- 66.pdf
- 67.pdf
- 68.pdf
- 69.pdf
- 70.pdf
- 71.pdf
- 72.pdf
- 73.pdf
- 74.pdf
- 75.pdf
- 76.pdf
- 77.pdf
- 78.pdf
- 79.pdf
- 80.pdf
- 81.pdf
- 82.pdf
- 83.pdf
- 84.pdf
- 85.pdf
- 86.pdf
- 87.pdf
- 88.pdf
- 89.pdf
- 90.pdf
- 91.pdf
- 92.pdf
- 93.pdf
- 94.pdf
- 95.pdf
- 96.pdf
- 97.pdf
- 98.pdf
59D-Link DIR-618 User Manual
Section 4 - Security
Congure WEP
It is recommended to enable encryption on your wireless router before you use wireless network adapters. Please
establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling
encryption due to the added overhead.
1. Log into the web-based conguration by opening a web browser and entering the IP address of the router (192.168.0.1).
Click on Wireless Setup on the left side.
2. Next to Security Mode, select Enable WEP Wireless Security (basic).
3. Next to Authentication, select Open.
4. Select either 64Bit or 128Bit encryption from the drop-down
menu next to WEP Encryption.
5. Next to Default Key Type, select WEP Key 1 and enter a WEP
key that you create. Make sure you enter this key exactly on all
your wireless devices. You may enter up to four different keys
either using Hex or ASCII. Hex is recommended (letters A-F and
numbers 0-9 are valid). In ASCII all numbers and letters are valid.
6. Click Save Settings to save your settings. If you are conguring the router with a wireless adapter, you will lose
connectivity until you enable WPA/WPA2-PSK on your adapter and enter the same WEP key as you did on the
router.