User's Manual
36
D-Link DIR-6 User Manual
Section 3 - Configuration
Select one of the following:
- Select only if all of your wireless clients are 802.11n.
- Select if you are using both 802.11b and 802.11g wireless clients.
- Select if you are using a mix of 802.11n, 11g, and 11b wireless clients.
Select the Channel Width:
- Select if you are not using any 802.11n wireless clients. This is the default setting.
- Select if you are using both 802.11n and non-802.11n wireless devices.
Check this box to reduce the guard interval time therefore increasing the data capacity. However, it’s less reliable and may
create higher data loss.
This section allows you to configure the MAC address of a computer, and allow or deny its access to wireless.
Use the drop-down list to select an SSID that has been configured in Wireless Network Name Setup.
Use the drop-down list to select an universal MAC filter rule for the MAC
addresses listed in the fields below.
Enter the MAC address for the rule. The format should be xx:xx:xx:xx:xx:xx.