User's Manual

18
D-Link DIR-6 User Manual
Section 3 - Configuration
Tick the check box to enable IP Unnumbered on LAN (1-3)
interface and NAT on Wireless Interface.
Enter your PPPoE user name.
Enter your PPPoE password.
Retype the new password.
Enter the ISP Service Name (optional).
Enter the IP address (Static PPPoE only).
Enter the IP netmask (Static PPPoE only).
Enter Start and End LAN IP address.
Click  to get the DNS automatically.
Click  to enter the DNS information
below.
Enter the Primary and Secondary DNS Server Addresses.

















Click  radio button if your ISP uses a static PPPoE connection. Your ISP will provide you with a username
and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.