User's Manual
Table Of Contents
- Table of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard
- Manual Configuration
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Access Control
- Website Filters
- Inbound Filters
- Firewall Settings
- Routing
- Advanced Wireless Settings
- Advanced Network Settings
- Administrator Settings
- Time Settings
- SysLog
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Log
- Statistics
- Internet Sessions
- Routing Table
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Troubleshooting
- Wireless Basics
- Networking Basics
45D-Link DIR-615 User Manual
Section 3 - Conguration
Change Password
Remote Management
Enter a new password for the Administrator Login Name. The administrator can
make changes to the settings.
Enter the new password for the User login. If you login as the User, you can only
see the settings, but cannot change them.
Enter a name for the DIR-615 router.
Enables a challenge-response test to require users to type letters or numbers
from a distorted image displayed on the screen to prevent online hackers and
unauthorized users from gaining access to your router’s network settings.
Check to enable HTTPS to connect to the router securely.
Remote management allows the DIR-615 to be congured from the Internet by
a web browser. A username and password is still required to access the Web-
Management interface. In general, only a member of your network can browse
the built-in web pages to perform Administrator tasks. This feature enables you
to perform Administrator tasks from the remote (Internet) host.
The port number used to access the DIR-615.
Example: http://x.x.x.x:8080 whereas x.x.x.x is the Internet IP address of the DIR-615
and 8080 is the port used for the Web Management interface. If you have enabled
HTTPS Server and checked Use HTTPS, you must enter https:// as part of the URL to access the router remotely.
This section will list any rules that are created. You may click the Edit icon to change the settings or enable/disable the rule, or click the Delete icon to
remove the rule.
Admin Password:
User Password:
Gateway Name:
Enable Graphical
Authentication:
Enable HTTPS Server:
Enable Remote
Management:
Remote Admin
Inbound Filter:
Details:
Administrator Settings
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management. There are two accounts that
can access the management interface through the web browser. The accounts are admin and user. Admin has read/write access while user has
read-only access. User can only view the settings but cannot make any changes. Only the admin account has the ability to change both admin and
user account passwords.