User Manual Part 2

65D-Link DIR-615 User Manual

Section 3 - Conﬁguration

Change Password

Remote Management

Enter a new password for the Administrator Login Name. The administrator

can make changes to the settings.

Enter the new password for the User login. If you login as the User, you

can only see the settings, but cannot change them.

Enter a name for the DIR-615 router.

Enables a challenge-response test to require users to type letters or

numbers from a distorted image displayed on the screen to prevent online

hackers and unauthorized users from gaining access to your router’s

network settings.

Check to enable HTTPS to connect to the router securely.

Remote management allows the DIR-615 to be conﬁgured from the

Internet by a web browser. A username and password is still required

to access the Web-Management interface. In general, only a member of

your network can browse the built-in web pages to perform Administrator

tasks. This feature enables you to perform Administrator tasks from the

remote (Internet) host.

The port number used to access the DIR-615.

Example: http://x.x.x.x:8080 whereas x.x.x.x is the Internet IP address of the DIR-615 and 8080 is the port used for the

Web Management interface. If you have enabled

HTTPS.Server and checked Use.HTTPS, you must enter https:// as

part of the URL to access the router remotely.

This section will list any rules that are created. You may click the Edit icon to change the settings or enable/disable the

rule, or click the Delete icon to remove the rule.

Admin Password:

User Password:

Gateway Name:

Enable Graphical

Authentication:

Enable HTTPS

Server:

Enable Remote

Management:

Remote Admin

Inbound Filter:

Details:

Administrator Settings

This page will allow you to change the Administrator and User passwords. You can also enable Remote Management.

There are two accounts that can access the management interface through the web browser. The accounts are admin

and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot

make any changes. Only the admin account has the ability to change both admin and user account passwords.