User's Manual

22D-Link DIR-605L User Manual
Section 3 - Conguration
To implement WPS, tick the Enable checkbox. Click either
Generate New PIN or Reset PIN to Default, then congure
the Wi-Fi settings below. Click Add Wireless Device with
WPS to connect a WPS-enabled device.
Select between Wireless Router, Access Point, WDS Only,
WDS +AP, WDS +AP +Router modes.
Check the box to enable the wireless function. If you do
not want to use wireless, uncheck the box to disable all the
wireless functions.
Service Set Identier (SSID) is the name of your wireless
network. Create a name using up to 32 characters. The SSID
is case-sensitive.
This setting can be selected to allow the DIR-605L to choose
the channel with the least amount of interference.
Indicates the channel setting for the DIR-605L. By default
the channel is set to 6. The channel can be changed to t
the channel setting for an existing wireless network or to
customize the wireless network.
Check this option if you would not like the SSID of your
wireless network to be broadcasted by the DIR-605L. If this
option is checked, the SSID of the DIR-605L will not be seen
by Site Survey utilities so your wireless clients will have to
know the SSID of your DIR-605L in order to connect to it.
Wi-Fi Protected
Setup:
Wireless Mode:
Enable Wireless:
Wireless Network
Name:
Enable Auto
Channel Selection:
Wireless Channel:
Enable Hidden
Wireless:
Wireless Connection
You can congure your specic wireless network settings in this section. Click Save Settings to apply them.