User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard (3G Mode)
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- Network Filters
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Advanced Network Settings
- Administrator Settings
- Time Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Logs
- Statistics
- Internet Sessions
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
61D-Link DIR-604 User Manual
Section 3 - Configuration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to
synchronize a wireless network. Specify a value.
100 is the default setting and is recommended.
This value should remain at its default setting of
2432. If inconsistent data ow is a problem, only
a minor modication should be made.
The fragmentation threshold, which is specied
in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte
setting will be fragmented before transmission.
2346 is the default setting.
(Delivery Trafc Indication Message) 1 is the
default setting. A DTIM is a countdown informing
clients of the next window for listening to
broadcast and multicast messages.
Select Short or Long Preamble. The preamble denes the length of the CRC block (Cyclic Redundancy Check is a common
technique for detecting data transmission errors) for communication between the wireless router and the roaming wireless
network adapters. Note: High network trafc areas should use the Short Preamble type.
Select None to disable this feature. Select Always to force the Router to require each wireless device on the network to
perform an RTS/CTS handshake before they are allowed to transmit data. Select Auto to allow the Router to decide when
RTS/CTS handshakes are necessary
Use the drop-down menu to select the wireless modes you want to enable on the Router. The available options are 802.11n
only, 802.11 Mixed (g/b), and 802.11 Mixed (n/g/b).
Use the drop-down menu to select 20MHz or 20/40MHz (Auto).
Transmit
Power:
Beacon
Period:
RTS
Threshold:
Fragmentation:
DTIM
Interval:
Preamble
Type:
CTS Mode:
Wireless
Mode:
Bandwidth:
Advanced Wireless Settings