User's Manual

60D-Link DIR-604 User Manual
Section 3 - Configuration
Firewall Rules
Enter a name for the rewall rule.
Use the drop-down menu to specify if the Router should
Allow or Deny trafc matching the rewall rule.
Use the drop-down menus to select the Source and Dest
(ination) interfaces for the rewall rule. You also may opt
to choose either LAN or WAN for each pair of interfaces.
Use these elds next to each Interface drop-down menu to
specify the IP address ranges for the Source/Destination
interfaces.
The rst host in the IP address range should be entered
in the top eld and the last host in the IP address range
should be entered in the eld beneath for both the Source/
Destination interfaces.
Use the drop-down menu to select the protocol that will be
used for the rewall rule (TCP, UDP, ICMP, or All).
Enter the range of ports that the rewall rule will apply to.
The rst port in the port range should be entered in the top
eld and the last host in the port range should be entered
in the eld beneath.
Use the drop-down menu to select the schedule for the
rewall rule. Click the Add New button to bring up the
Schedule page to congure the new schedule.
Name:
Action:
Interface:
IP Address:
Protocol:
Port Range:
Schedule:
To create a rewall rule, congure the parameters
described below: