User's Manual

43D-Link DIR-604 User Manual
Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide
you with a username and password. This option is typically used for DSL services. Make sure to remove your PPPoE
software from your computer. The software is no longer needed and will not work through a router.
Manual Internet Configuration (PPPoE)
Select PPPoE (Username/Password) to obtain IP address
information automatically from your ISP. Select this option
if your ISP does not give you any IP numbers to use.
Select Static IP if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most
cases, users will select Dynamic IP (DHCP).
Enter your PPPoE user name.
Enter your PPPoE password.
Retype the PPPoE password entered above.
Enter the ISP service name (optional).
Enter the IP address (Static PPPoE only).
The default MAC address is set to the Internet port’s physical
interface MAC address on the broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP. You can use the Copy Your
PC’s MAC Address button to replace the Internet port’s MAC
address with the MAC address of your Ethernet card.
Enter the primary DNS server address (Static PPPoE only).
My Internet
Connection
is:
Address
Mode:
User Name:
Password:
Confirm
Password:
Service
Name:
IP Address:
MAC
Address:
Primary DNS
Server: