User's Manual

42D-Link DIR-604 User Manual
Section 3 - Configuration
If you opt to set up your Internet connection manually, you will be redirected to a WAN page that allows you to select
your Internet type and enter the correct conguration parameters.
Manual Internet Configuration (Dynamic IP)
Select Dynamic IP (DHCP) to obtain IP address information
automatically from your ISP. Select this option if your ISP
does not give you any IP numbers to use.
The host name is optional but may be required by some
ISPs. Leave blank if you are not sure.
The default MAC address is set to the Internet port’s physical
interface MAC address on the broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP. You can use the Copy Your
PC’s MAC Address button to replace the Internet port’s
MAC address with the MAC address of your Ethernet card.
Enter the primary DNS server IP address assigned by your
ISP. This address is usually obtained automatically from
your ISP. Leave at 0.0.0.0 if you did not specically receive
an address from your ISP.
Enter the secondary DNS server IP address assigned by
your ISP. This address is usually obtained automatically
from your ISP. Leave at 0.0.0.0 if you did not specically
receive an address from your ISP.
Maximum Transmission Unit. You may need to change the
MTU for optimal performance with your specic ISP. The
default is 1500.
My Internet
Connection
is:
Host Name:
MAC
Address:
Primary DNS
Server:
Secondary
DNS Server:
MTU:
Click the Save Settings button when you have nished conguring the Internet connection.