User's Manual

20D-Link DIR-604 User Manual
Section 3 - Configuration
Set the transmit power of the antennas.
Beacons are packets sent by an Access Point to
synchronize a wireless network. Specify a value.
100 is the default setting and is recommended.
This value should remain at its default setting of
2432. If inconsistent data ow is a problem, only
a minor modication should be made.
The fragmentation threshold, which is specied
in bytes, determines whether packets will be
fragmented. Packets exceeding the 2346 byte
setting will be fragmented before transmission.
2346 is the default setting.
(Delivery Trafc Indication Message) 1 is the
default setting. A DTIM is a countdown informing
clients of the next window for listening to
broadcast and multicast messages.
Select Short Preamble or Long Preamble.
The preamble denes the length of the CRC block (Cyclic Redundancy Check is a common technique for detecting data
transmission errors) for communication between the wireless router and the roaming wireless network adapters. Note: High
network trafc areas should use the Short Preamble type.
Select None, Always, or Auto.
Use the drop-down menu to selec the wireless modes you want to enable on the router. The available options are 802.11n
only, 802.11 Mixed (g/b), and 802.11 Mixed (n/g/b).
Tick this check box to reduce the guard interval time therefore increasing the data capacity. However, it is less reliable and
may create higher data loss.
Transmit Power:
Beacon
Period:
RTS
Threshold:
Fragmentation:
DTIM
Interval:
Preamble
Type:
CTS Mode:
Wireless
Mode:
Short Guard
Interval:
Advanced Wireless Settings