User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Easy Setup Wizard
- Manual Configuration
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Traffic Control
- Network Filters
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Advanced Network Settings
- Administrator Settings
- Time Settings
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Device Information
- Log
- Stats
- Internet Sessions
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
- Technical Specifications
13D-Link DIR-603 User Manual
Section 3 - Conguration
According to the detection result, the wizard will
indicate the type of Internet connection that you’re
currently use.
You can configure your wireless network. Click
Congure button in Wireless Settings. Select the
type of Wireless security you use (Disable Wireless
Security or AUTO-WPA/WPA2) and enter the
network name (SSID, Service Set Identier) and
security password. The network name(SSID) is the
name of your wireless network. Create a name using
up to 32 characters.
If the type is Dynamic IP(DHCP), click Save to
continue.
If the type is PPPoE, enter your PPPoE username
and password. Click Next to continue.
If the type is Static IP, please enter the IP
address, subnet mask, gateway, and DNS server
addresses that your ISP assigned to you. Click
Connect to continue.
Note: Make sure to remove your PPPoE software
from your computer. The software is no longer
needed and will not work through a router.