User's Manual

Section 3 – Configuration
————————————————————————————————————————————————————————————
D-Link DIR-524 User Manual 22
Wireless Basic Settings
Use this section to configure the wireless settings for your D-Link Router. Please note that changes made on this
section may also need to be duplicated on your Wireless Client.
Enable Wireless:
Select Enabled to enable the wireless
function. If you do not want to use wireless,
select Disabled.
Wireless Network
Name:
Service Set Identifier (SSID) is the name of
your wireless network. Create a name
using up to 32 characters. The SSID is
case-sensitive.
Channel:
Indicates the channel setting for the
DIR-524. By default the channel is set to 6.
The Channel can be changed to fit the
channel setting for an existing wireless
network or to customize the wireless
network.
SSID Broadcast:
When select on, your wireless network
name is broadcast to anyone within the
range of your signal. If you're not using
encryption then they could connect to your
network. When select off, SSID will hide,
you must enter the SSID on the client
manually to connect to the network.
AP Isolation :
Selecting On enables AP isolation mode.
When enabled, STAs associated to the AP
will not be able to communicate with each
other.