User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard (3G Mode)
- Manual Configuration (3G Mode)
- Internet Connection Setup Wizard (WAN Mode)
- Manual Configuration (WAN Mode)
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- Advanced Network Settings
- Administrator Settings
- Time Settings
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Logs
- Statistics
- Internet Sessions
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
5D-Link DIR-412 User Manual
Section 1 - Product Overview
Internet LED
A solid green light indicates a
successful 3G connection. A solid
orange light indicates a 3G error, a
WAN failure, or a system failure. A
blinking green light indicates that the
WAN connection is enabled when the
Router is operating in WAN mode.
WLAN LED
A solid green light indicates that
the wireless segment is ready.
This LED blinks during wireless
data transmission.
Power LED
Lights orange during bootup. Lights
green when router has booted
up. A solid green light indicates
a proper connection to the power
supply. If the LED blinks orange
the system has failed.
Ethernet LED
A solid green light indicates that a link
has been established. This LED blinks
during data transmission.
Hardware Overview
Top View
WPS Button
Press the WPS button for 1 second to
initiate the WPS process. The button will
ash blue while a WPS connection is being
established. The button will light blue for 300
seconds if a successful WPS connection
has been made.
3G USB Connection
Connect your 3G USB dongle to this
port if you want to use a 3G Internet
connection.