User's Manual

60D-Link DIR-412 User Manual
Section 3 - Configuration
Change Password
Remote Management
Enter and conrm a new password for the Administrator
Login Name. The administrator can make changes to
the settings.
Check this box to enable graphical authentication. The
device supports this function to prevent phishing.
Remote management allows the DIR-412 to be
configured from the Internet by a web browser. A
username and password is still required to access the
Web-Management interface. In general, only a member
of your network can browse the built-in web pages to
perform Administrator tasks. This feature enables you to
perform Administrator tasks from the remote (Internet)
host.
The port number used to access the DIR-412.
Example: http://x.x.x.x:8080 whereas x.x.x.x is the
Internet IP address of the DIR-412 and 8080 is the port
used for the Web Management interface.
Admin Password:
Enable Graphical
Authentication:
Enable Remote
Management:
Remote Admin
Port:
Administrator Settings
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management.
There are two accounts that can access the management interface through the web browser. The accounts are admin
and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot
make any changes. Only the admin account has the ability to change both admin and user account passwords.