User's Manual
Table Of Contents
- Preface
- Product Overview
- Installation
- Configuration
- Web-based Configuration Utility
- Internet Connection Setup Wizard (3G Mode)
- Manual Configuration (3G Mode)
- Internet Connection Setup Wizard (WAN Mode)
- Manual Configuration (WAN Mode)
- Wireless Settings
- Network Settings
- Virtual Server
- Port Forwarding
- Application Rules
- QoS Engine
- Network Filters
- Website Filters
- Firewall Settings
- Advanced Wireless Settings
- Wi-Fi Protected Setup
- Advanced Network Settings
- Administrator Settings
- Time Settings
- E-mail Settings
- System Settings
- Update Firmware
- DDNS
- System Check
- Schedules
- Device Information
- Logs
- Statistics
- Internet Sessions
- Wireless
- Support
- Web-based Configuration Utility
- Wireless Security
- Connect to a Wireless Network
- Troubleshooting
- Wireless Basics
- Networking Basics
35D-Link DIR-412 User Manual
Section 3 - Configuration
Select Static IP if your ISP assigned you
the IP address, subnet mask, gateway, and
DNS server addresses. In most cases, select
Dynamic IP.
Enter the L2TP IP address supplied by your ISP
(Static IP only).
Enter the Subnet Mask supplied by your ISP
(Static L2TP only).
Enter the Gateway IP address provided by your
ISP (Static L2TP only).
Enter the Server IP address provided by your
ISP (optional).
Enter your L2TP user name.
Enter your L2TP password and then retype the
password in the next box.
Select either Always-on, On-Demand, or
Manual.
Address Mode:
L2TP IP Address:
L2TP Subnet
Mask:
L2TP Gateway IP
Address:
L2TP Server IP
Address:
User Name:
Password:
Reconnect Mode:
Choose L2TP (Username/Password) from the My Internet Connection is drop-down menu if your ISP uses an L2TP
connection. Your ISP will provide you with a username and password. This option is typically used for DSL services.
Manual Configuration (WAN Mode)
L2TP (Username/Password)