User's Manual

Table Of Contents
13D-Link DIR-412 User Manual
Section 2 - Installation
If you are using a 3G USB dongle to connect to the Internet, please follow the steps below:
1. Move the WAN Mode/3G Router Mode switch on the DIR-412 so that it is in the 3G Router Mode position.
2. Place the router in an open and central location. Do not plug the power adapter into the router.
3. Turn the power off on your modem. If there is no on/off switch, then unplug the modem’s power adapter. Shut down
your computer.
4. Insert your 3G USB dongle into the DIR-412’s 3G USB Internet connection.
5. Unplug the Ethernet cable (that connects your computer to your modem) from your computer and place it into the
Ethernet port on the router.
6. Turn on or plug in your modem. Wait for the modem to boot (about 30 seconds).
7. Plug the power adapter to the router and connect to an outlet or power strip. Wait about 50 seconds for the router
to boot.
8. Turn on your computer.
9. Verify the link lights on the router. The power light, Internet light, and the Wireless LAN light should be lit. If not,
make sure your computer and router are powered on and verify the cable connections are correct.
10. Skip to “Conguration” on page 16 to congure your router.
Connect to a 3G Internet Service