- D-link DCS-900 Internet Camera ManualVersion 1.10
Table Of Contents
- Table of Contents
- Package Contents
- System Requirements
- Introduction
- Features and Benefits
- Connections
- LEDs
- Hardware Installation
- Security
- Using the Setup Wizard
- DCS-900 Configuration
- IPView Lite Application Installation
- IPView Lite - Getting Started
- Uninstall IPView Application
- Appendix A: Frequently Asked Questions
- Troubleshooting
- Appendix B: How to PING your IP address
- Time Zone Table
- Xplug Control Installation
- Adjusting the Camera Focus
- Technical Specifications
- Contacting Technical Support
- Warranty and Registration
9
Hardware Installation
Connect the Ethernet Cable
Connect the included Ethernet cable to the network
cable connector located on the back panel of the
DCS-900 and attach it to the network. Network
Connectivity is confirmed when the orange LED
Indicator on the DCS-900 located below the Power LED
is illuminated.
Attach the External Power Supply
Attach the external power supply to the DC power input
connector located on the rear panel of the
DCS-900 and connect it to your local power supply.
Note: Power source is confirmed when the green LED
Power Indicator located to the right of the lens on the
DCS-900 is illuminated.
Attach the Swivel Stand
Locate the stand connector on the bottom panel of the
DCS-900 and screw on the swivel stand to the base of
the DCS-900.